Pillow Block Bearing Guard

More Views

Pillow Block Bearing Guard
Price From: $55.00
Pillow Block Bearing Covers and guards are installed to protect against contact with rotating bearings.

* Required Fields

Price From: $55.00
Details

Details

Pillow Block Bearing Guard - Shaft Cover

These covers are used to cover pillow block bearings. A slot can be made in one side if a shaft protrudes on one side, or slots on both sides for a through shaft. The covers are fastened to the structure the bearing is attached to by the flange, by drilling two holes in the flange and the underlying structure and using self-tapping screws or nuts and bolts. Part of the flange can be trimmed off if there are interference issues.

  1. Begin by finding the height of the space you need covered. Guards are measured in inches from their inside dimensions. Dimension (A)
  2. Next, find the width and length of the space that you need covered. Dimension (B & C)
  3. Finally, measure the width to center length. Dimension (K)
  4. Note: the E1 and E dimensions are 0" for the prices listed below.  Contact us for a quote if you wish them to be otherwise.  

Guard is "Black" (other colors available for a fee - yellow, orange, gray and clear)

bearing cover schematic

Part Number Height "A" Width "B" Length "C" Width to Center "K" Height to Center "M" Price
MG08-01 2-7/8 2-1/2 5-1/8 1-1/4 1-1/8 $55.00
MG08-02 3 2-3/4 5-3/8  1-3/8 1-1/4 $55.00
MG08-03 3-1/4 3-1/8 5-5/8 1-1/2 1-7/16 $55.00
MG08-04 3-3/4 4-1/8 6-3/8 1-5/8 1-3/4 $55.00
MG08-05 3-3/4 4-1/8 6-3/4 2 1-7/8 $55.00
MG08-06 4-3/8 3-5/8 7-1/8 2-1/8 2 $55.00
MG08-07 5-1/4 4-3/4 7-7/8 2-7/8 2-3/8 $75.00
MG08-08 5-1/8 5 8-7/8 2-7/8 2-3/8 $75.00
MG08-09 6-1/8 5-3/8 9-3/8 2-7/8 3 $100.00
MG08-10 7 6 10-3/4 3-1/4 3-3/8 $150.00
MG08-11 7-3/4 4-1/4 12-1/4 2-7/8 3-1/2 $150.00
Reviews